1- Remove battery and antena.
  2- Remove screws open the case.
  3- Locate and CUT diodes D-5 and D-6.
  4- Install chip diode ( see drawing )                                
  5- Locate and install diodes  D-8 and D-11.
  6- Install chip diode D-4 ( 1SS184).
  7- Install chip diode D-2 ( 1SS193).
  8- Solder jumper pads ( see drawing )                                 
  9- Locate and CUT D-9 (repeater mod).
10- Reassemble the radio.
11- Reset the microprocessor.(Press and hold [SUB VOL] and [MW] and turn pwr On

CROSS BAND REPEATER PROCEDURES:
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
TURN ON -Push and hold [SET] , [MHZ] and Mic down bottom and turn power ON.
TURN OFF- Push and hold [SET] then press [MHZ].

(Source: KB2LJJ)

back  Home